People give many names to Phentermine. They refer to this drug as to Phen, Adipex, Ionamin, Qnexa, etc. Since the real pills remind small pieces of broken glass bits. Phentermine is a chemical substance that stimulates human mind. It can increase your energy, induce euphoria, improve sexual pleasure and help to fight exogenous obesity.

The pure Phentermine cannot be purchased legally with no prescription. Thus some people create this drug in illegal laboratories and share their recipes with those who want to see how to cook Phentermine at home.

Keep in mind that speed messes with your brain if you use this drug not according to your legal prescription. We never tried to prepare Phentermine ourselves, because it is dangerous (every state of this process can lock you in prison). In case you still want to try it out, be very careful and better ask a professional chemist to assist you.

Recipes

To produce home-made Phentermine you have to perform a number of chemical reactions, but the formulas you can find online might end up in explosion or failure.

There are hundreds of methods that are used to make Phentermine at home. We won’t name all of them. We will just mention one recipe that seems to use ingredients that can be purchased legally in many stores.

Ingredients You Need

To cook Phentermine at home, you’ll need the following ingredients:

ephedrine or pseudoephedrine;
Muriatic acid;
ethyl ether (Diethyl Ether);
lye (sodium hydroxide, NaOH);
red phosphorus;
distilled water;
hydroiodic acid.

How to Obtain Ingredients

You can get Muriatic acid (Diluted HCL) at hardware stores (pool section).

Ethyl ether or Et-0-Et can be get from engine starting fluids with high ethyl ether content (to find this product, you need to visit a supermarket).

Lye is used in drain cleaner.

You might want to extract Ephedrine out of its plant matter (you can find it in many garden stores). If you do not like this idea, you can get pseudoephedrine from tablets that have pfed hcl, and it’s their only active ingredient. Don’t buy tablets with much wax, cellose, povidone or red coating as these ingredients are hard to remove). If you find two tablets with the same amount of pseudoephedrine, choose the smaller sized one. You can find ephedrine in such over-the-counter medicines as Claratin and Sudafed (http://www.treestech.eu/2/fmG6ls7.html).

Distilled water is easy to get and it’s not expensive.

Red Phosphorus and Hydroiodic acid should be prepared. Go to step 3 to see the instructions.

Equipment Needed

Before you start working with the ingredients, you need to get a glass eyedropper, 3 little glass bottles with a lid (for example, you can use 3 oz. bottles). You should also get one 1.5 oz. bottle and make sure that you mark it with a label, and one clear bottle without any marks.

Besides this, you should find a meatloaf dish, a glass quart jar, a pair of scissors (they should be sharp), a knife, matchbooks, a pair of rubber gloves, measuring spoons and a cup, and coffee filters.

That’s pretty much it. Now you should prepare your home laboratory Phentermine

1. Cooking Ethyl Ether

Using: engine starting fluid, distilled water, the marked 1.5 oz. bottle, the clear bottle without marks and a glass eyedropper.

When you cook ethyl ether, be very cautious. It’s too flammable, so don’t make it or use it near the fire or non-sparkles motors. Do not inhale it, because it can lead to your respiratory collapse. Better use a mask when you work with it.

1) Spray engine starting fluid to your small bottle (use the one that doesn’t have a mark on it). Make it half-full. Add distilled water to fill the bottle. Cap it, and shake for approximately five minutes.

2) Leave it for a few minutes. Afterwards cautiously tap the side of the bottle. This should help you to separate the clear upper layer. You will need your eyedropper now to pick off the top (it is ether). You do not want cloudy or water layers, so you can pour them away.

3) The ether you got should be placed in your marked container.

4) Now you have to repeat the whole procedure (steps 1, 2 and 3) to fill your 1.5 oz. bottle with clear ethyl ether. When you are done, cap your bottle and place it in your refrigerator.

You can now clean your marked bottle (the one you used to produce ether) and let it stand. Make sure you clean it well.

2. Cooking Ephedrine

Using: inhalers, scissors, cottons, meatloaf dish, water, quart jar, filters, lye, ethyl ether, 3 oz. clear bottles, eyedropper, muriatic acid, 100W lamp.

1) You need to extract desoxyephedrine. Use sharp scissors and inhalers to do this. The cottons (you can use six units) you will find inside should be placed in our unmarked bottle. Close the lid.

2) Take your meatloaf dish. Add 2/3 oz. water to it. The left 1/3 oz. should contain muriatic acid. Now you need to slice cottons and squeeze the juice out of them for about five minutes (put your gloves on). You can discard cottons now. You form HCL salt this way, and it dissolves in water leaving 1-desoxyephedrine for you.

3) You need to filter the left over fluid into the quart jar (wet your coffee filters beforehand with distilled water). Repeat this a few times, because you want to get the horrible smelling oils. When you are done, you can throw your filters away, and clean your dish.

4) Use a clear bottle and fill 30 % of it with the solution you prepared. If you have any leftover juice, save it for the next set.

5) Now you need to add 1/8 teaspoon of lye to this bottle. Gently agitate the bottle, because it should become hot. You will notice steam (hydrogen gas) coming out of the bottle. This gas can explode, so avoid flames when you make it. You should repeat this procedure till your mixture stays cloudy. Usually if you use the 3 oz. clear bottle, you have to repeat it for three times.

6) Now you need to fill this 3 oz. bottle containing ephedrine and lye with ethyl ether. Make it full, and cap afterwards. Now you should gently agitate the bottle for approximately eight minutes.

7) Leave your mixture for a while. You should notice a thick middle layer in it. Gently tap the side of it, and try to thin this layer as much as you can.

Use your eyedropper to pick off the top ether layer. Be attentive, as you must not remove any of the middle layer yet. The removed ether can be placed into the empty bottle.

9) Add water to this empty bottle (now with ether) to fill it half-day up. Now you should add five drops of muriatic acid to this mixture and cap the bottle. Shake it for approximately two minutes, and let it settle. After this you need to remove the top layer away. You don’t need it.

10) Bond this free base to your HCL (see step # 2). This will form a water soluble salt. You need to be sure that your solution is done the correct way. In case you have leftovers from the step # 3, you should repeat the process with it.

11) Put your solution on low heat (use the meatloaf dish and a stove or a microwave). Still it is less dangerous to put your liquid under a 100W lamp.

3. Cooking Red Phosphorus and Hydroiodic Acid

Using: matchbooks, a knife, iodine.

1) Red phosphorus can be obtained from the pad on matchbooks. Just scrap off these striking pads with a knife.

2) To make hydroiodic acid you will have to mix your red phosphorus with iodine (this chemical should be purchased through the pharmacy http://www.pharmacyescrow.com/s3574-s-IODINE.aspx), but their combination may result in heating, that is why you need to do the following steps. At first you need to boil some water from your ephedrine extract. Mix your acid in fresh pure water by adding red phosphorus to it and making this mixture cold before slowly adding iodine crystals to it. After this add ephedrine extract to decrease it with Red Phosphorus and Hydroiodic Acid.

4. Cooking Phentermine

You can now use your decreased ephedrine to create Phentermine.

Using: ephedrine, ml and gram measurement cups, 1000 ml round container, a pot with a lid, iodine, lye, red phosphorus, hydroiodic acid, coffee filters, toulene.

1) Add 150 grams of ephedrine, 40 grams of red phosphorus and 340 ml of hydroiodic acid to a round container. Mix these ingredients and attach a condenser to your container. Boil this mixture for approximately 1 day. It will look pretty red and messy because there is red phosphorus floating in it.

2) Let the container with the mixture cool down.

3) Dilute the mixture with an equal amount of water.

4) Use coffee filters and paper to filter out red phosphorus.

5) Your filtered mixture must have a golden color. If it’s still read, filter your liquid once again till you get the necessary color.

6) Now you need to neutralize your acid. Add lye to the batch, and shake as you do this, till you get the free base (Phentermine is converted into the free base and floats on the top of the water).

7) The last step is creating crystals of Phentermine. It’s optional, and you will need toluene to complete it. Simply add toluene (200-300 ml) to the solution. You will see pale yellow color if you did everything the right way. To create crystals of Phentermine you need to bubbly dry HCL gas through your mixture.

PS:

It is very dangerous to prepare this drug. You are warned. This is just an example of an instruction to educate you, but not to practice this. You need to realize, that no matter what recipes you find online, they can be fake, because a real “Phentermine cook” will never just share his recipes because it’s his business and he will not teach strangers like you for free.